Forum: Street & Strip

2 sets left, these go in the rear of the heads after soft plugs are out, drilled and tapped for a no.8 fitting.

damn, i been here 1 day and i'm bored to death..post some questions..talk some smack..something, anything, lol.. i am in california..who wants...

I have a 67 400 engine that I had rebuilt by a local machine shop. They installed cam & the heads also. When I looked at the lifters against the cam...

Just looking through some of your old 85 GP pictures. What do you think that car would have run if you had taken it to the track?

I know headers are better for performance but what about someone who wants to run manifolds on their street car but still run well. Can one build a...

I've just bolted the heads on to my 400 & was about to fit the valley cover when I noticed that the cam & lifters look really`dry'. Is it a good...

I have a pair of 1967 `061 heads, they have 2.11/1.77 valves but the rocker studs are press in, they appear to be be in really good condition & the...

Will a flexplate off a 400 fit a 326? Thanks, Shane. :)

Here are a few pics of the 416 motor going in to the 85GP. :) Shouldn't be too long now [-o<

Hello, I just had billet steel 4 bolt main caps with studs installed on a 455 block, then had it align bored and honed. When running a dial bore...

I need front and rear throttle blades for my tri-power carbs. bore measures 1.687 and the blades are close to .077 thick, anybody know where i can...

i WILL rebuild your Pont. q-jet, includes removing idle tubes, new kit with new jets, set float level, make sure sec. open a full 90 degree,s for a...

Aybody have anything they wish to part with?? e-mail me anytime Please delete

What was the purpose of switching to shorter valves on the 71 and later heads. I was at the 75th pontiac Aniv. held in Redwing MN. and asked this...

I seen it somewhere that states!! Big boys do it with 10-1/2 inches, street car on the front, Help me out gang!!Please delete